Cabletron Systems WPIM T1 - Manual (Page 47)

WPIM-T1/DDS User’s Guide 4-1
CHAPTER 4
LOCAL MANAGEMENT FOR DDS SERVICE
This chapter explains how to configure the WPIM-T1/DDS through Local
Management. The WAN Physical Configuration screen and the WAN
Interface Configuration screen display as Local Management menu
selections after the WPIM-T1/DDS is installed into a host platform. Refer
to the host platform User’s Guide for instructions about how to set up and
access Local Management.
Sections of this chapter include the following:
• The WAN Physical Configuration Screen, Section 4.1
• The WAN Interface Configuration Screen, Section 4.2
• WPIM-DDS Configuration, Section 4.3
Read Section 4.1 and Section 4.2 to gain an understanding of the
WPIM-T1/DDS Local Management screens. Section 4.3 provides
examples for setting up the WPIM-DDS in a PPP or Frame Relay
environment.
NOTE
The WPIM-T1/DDS cannot operate in both T1 and DDS mode
at the same time. The user must choose the appropriate
service, but can change it when desired. Refer to
Section 2.3.1
to choose the mode.
When the WPIM-T1/DDS is first powered up, the default is T1.