Cabletron Systems WPIM T1 - Manual (Page 35)

Full T1 Configuration Using PPP
WPIM-T1/DDS User’s Guide 3-11
3.3 FULL T1 CONFIGURATION USING PPP
This section provides step-by-step instructions for configuring the
WPIM-T1/DDS to use a full T1 circuit in a PPP environment. This
simplified example assumes the setup shown in
Figure 3-6 using a
CSX400 with a WPIM-T1/DDS installed at Site #1. Configurations may
vary depending on the host platform.
Figure 3-6 Full T1 Configuration
The line configuration information shown in Table 3-1 must be supplied
by the service provider.
Table 3-1 Telco Configuration Information
Configuration Information
Required by User Configuration Information
Supplied by Service Provider
Line Coding B8ZS or AMI
Frame Type ESF or D4
Clock Source Loop Timing or Local Timing
SITE #1
Telco Cloud
24 Timeslots
24 Timeslots
SITE #2
1482_05