2 wan configuration, Wan configuration -5, Section 2.3.2 – Cabletron Systems WPIM T1 User Manual
Page 23
Required Operations
WPIM-T1/DDS User’s Guide
2-5
This is done using Network Tools, or MIB Navigator, depending on the
host platform. Refer to the host platform user’s guide for information on
how to navigate through the Local Management screens in order to access
Network Tools.
Follow these steps to configure the WPIM-T1/DDS for T1 or DDS
service:
1.
Once in Network Tools, choose between T1 and DDS setup using this
command:
t1dds
where SLOT is either 1 for slot one of the host platform for the WPIM,
or 2 for slot two, and T1/DDS is either 1 for DDS service, or 2 for T1
service.
2.
Assuming the WPIM-T1/DDS is installed in slot 1, use the following
command to allow the WPIM-T1/DDS in slot 1 to perform T1 service:
t1dds 1 2
To perform DDS service, use the following command, also for slot 1:
t1dds 1 1
3.
Press the ENTER key. The unit automatically reboots and the user
must re-enter Local Management.
2.3.2
WAN Configuration
The WPIM-T1/DDS must be configured for WAN operation using either
QuickSET or Local Management before the WAN is connected.
Refer to the QuickSET manual for specific instructions on how to access
the Wide Area configuration for the WPIM-T1/DDS. Refer to
in order to obtain the QuickSET manual.
For Local Management configuration, refer to
for T1
for DDS configuration.
The WAN configuration from QuickSET or either
must be completed before proceeding to the next step.