tekmar 667 Snow Detector & Melting Control - Manual (Page 21)

21 of 28 © 2002 D 667 - 09/02
667 Monitor Menu (2 of 2)
Note: To clear the recorded information in the specific item field, press and hold ▲ and ▼.
Item Field Description Range
Access
Level
LT
D
USER INS
T
AD
V
1 to 24 hr, OFF
Default = OFF
This item is an adjustable warning. If the slab temperature
does not reach the slab target temperature within the set time,
the control displays a warning message.
The number of times that the microprocessor in the control
has reset since this item was last cleared. The control will
reset itself if it has experienced some form of interference
that has disrupted its operation. This can be used to give an
indication of the quality of the electrical environment that the
control has been installed in.
The number of times that the control has been powered up
since this item was last cleared. This number will increase if
there is a lowering of the input voltage beyond the control’s
usable range. This item can be used as an indication of the
quality of the power source.
0 to 255
0 to 255
The number of times that a communication error has been
detected between the control and either an RDM or Remote
Start / Stop Module since this item was last cleared. If the wires
between the control and the tekmar Net™ tN2 device are run
in a noisy electrical environment, this can cause interference in
the communication between the control and the tN2 device.
0 to 255
667 Schd (Schedule) Menu (1 of 1)
NONE, AWAY (Ovr)
Default = NONE
B1
The setback override that is in effect for the snow
melting system.
Item Field
Access
Level
Description Range
Section LT
D
USER INS
T
AD
V