Device settings and tests, 1 midi channel assignment, 2 jog wheel calibration – Reloop CONTOUR INTERFACE EDITION User Manual
Page 36: Engli sh

ENGLI
sh
36
5. DEvICE sETTINGs AND TEsTs
There are a few settings and tests which can be carried out directly with Contour without the need
for a computer. In the following a few points will be explained more thoroughly.
5.1 MIDI ChANNEL AssIGNMENT
ATTENTION!
By default Contour is configured for channels 1-4. Deck A is assigned to channel 1, deck B is
assigned to channel 2, deck C is assigned to channel 3, and deck D is assigned to channel 4.
Reloop‘s official mappings are laid-out for the standard configuration. Usually there is no need
to change these.
Should you, however, wish to assign the decks to the MIDI channel combination 5-8, 9-12, or 13-16
proceed as follows.
1. Make sure that Contour is turned off (see ON/OFF Button -B36-).
2. Press and hold the Shift Button -T29- and turn on Contour via the ON/OFF Button -B36-.
3. Now release the Shift Button -T29-.
4. via the FX Buttons -T1 – T4- you can select the desired channel combination.
5. By pressing the Shift Button -T29- one last time the selection is saved and the Controller will
be rebooted. The new MIDI channels have now been determined.
5.2 JOG WhEEL CALIBRATION
Should the Jog Wheel -T28- not react correctly any more, its touch-sensitivity can be recalibrated.
Proceed as follows.
1. Make sure that Contour is turnd off (see ON/OFF Button -B36-).
2. Press and hold the Play/Pause Button -T32- and turn on Contour via the ON/OFF Button -B36-.
3. Now release the Play/Pause Button -T32-.
4. Then touch the Jog Wheel‘s -T28- metal surface. Simultaneously the feedback LEDs that are
placed around the Encoder -T7/9- should go out from the right to the left.
NOTE!
It is not necessary that all LEDs go out. however, the LED circle around the Effect section‘s
Encoder -T9- on the right side should go out.
If this is not the case there may be an error. Please refer to the chapter „Troubleshooting“ in
the appendix.
5. Release your finger from the surface and in the following press the Play/Pause Button -T32- in
order to complete the calibration procedure. The controller will automatically reboot.
MIDI-ChANNEL-COMBINATION
FX-BUTTON
1 - 4
1
5 - 8
2
9 - 12
3
13 - 16
4