Reloop CONTOUR INTERFACE EDITION - Manual (Page 27)

ENGLI
sh
27
- Connect the RCA stereo output „Out 1“ -B41- to channel 1 of your mixing console.
- Connect the RCA stereo output „Out 2“ -B41- to channel 2 of your mixing console.
- If you have a 4 channel mixing console at your disposal connect the RCA stereo outputs „Out 3“
and „Out 4“ -B41- to channels 3 and 4 of your mixing console.
- For monitoring it is necessary to connect your headphones to the mixing console.
3. COMPUTER CONFIGURATION
Before you can use your new device a few basic computer adjustments have to be carried out.
ATTENTION!
Please make sure that your Reloop Contour is turned off. You will be asked during the installati-
on to turn the device on.
The included UsB cable can already be connected (see item Basic steps).
Please especially observe the following explanations.
3.1 AsIO DRIvER INsTALLATION
Insert the included installation CD into your computer‘s drive. Select the driver that best suits
your system in the „Drivers“ folder and start the installation via a double click.
TIP!
Reloop regularly provides updated drivers online. For more information please read the chapter
„Updates & Support“.
NOTE!
Please make sure to start the driver installation with admin rights. Otherwise the installation
will fail with an error message.
If you use Windows Vista or Windows 7 please carry out the appropriate installation setup via a
click of the right mouse button followed by the selection „Run as admin“.
1. First of all you will enter the language select window. Please select your preferred language.
2. Now click on the „Install the driver“ button.
3. Now you will be asked to connect and turn on your Reloop Contour. If your Reloop Contour has
not been connected via USB please connect the included USB cable to Contour‘s USB port
-B40- and a free USB port of your computer. Also connect the included mains adapter to the
corresponding connector -B38-.
Now turn on the device via the ON/Off Button -B36-.