E-flite J-3 Cub 25 ARF User Manual

Page 39



11. Remove the T-pins from the hinges and use thin

CA to glue them in place. Allow the epoxy and
CA to cure before continuing to the next step.



12. Snap the clevis onto the control horn and use

tape to hold the rudder centered. Mark the
pushrod where it crosses the servo horn using a
felt-tipped pen.

Note:.Ensure.the.radio.is.turned.on.with..

the.trims.and.sub-trims.centered.and.the..

servos.are.centered.