E-flite J-3 Cub 25 ARF - Manual (Page 37)

 5. Attach the tail wheel using the 2mm wheel collar
and the 3mm setscrew.
 6. Slide a clevis retainer onto a clevis, then thread
the clevis onto a 25 5 /
8
" (650mm) pushrod wire.
Slide the pushrod wire into the opening as shown.
 7. Place T-pins in three of the CA hinges. Slide the
hinges into the rudder, and then slide the rudder
into position. Use tape to hold the rudder in
position.
DO NOT glue the hinges or tail wheel
until instructed to do so.
37