E-flite J-3 Cub 25 ARF User Manual

Page 20



4. Slide the aileron and wing together. Remove

the T-pins. There should be a 1/64" (.4mm) gap
between the aileron and wing. Make sure the
aileron can move freely without binding.

Note:.The.aileron.has.a.block.installed.for..

the.aileron.control.horn.to.mount.to..Make..

sure.this.block.is.located.on.the.inboard.side..

of.the.wing.



5. Deflect the aileron and apply thin CA to

each of the hinges. Make sure to saturate each
hinge. Apply CA to both the top and bottom
of the hinges.

Note:.Do.not.use.accelerator.in.the.hinging.

process..The.CA.must.be.allowed.to.soak.into.

each.hinge.naturally.