E-flite Cessna 150 Aerobat 250 ARF - Manual (Page 9)

9 E-flite Cessna 150 Aerobat 250 ARF Assembly Manual
 4. Use a pin vise and a #56/.046-inch (1mm) drill
bit to drill the holes for the mounting screws. Use
care not to push too hard on the mounting rails as
this could damage them.
 5. Apply 2–3 drops of thin CA in each of the holes
to harden the surrounding wood. This will harden
the threads so the screws do not easily strip the
surrounding wood.
 6. Use the screws provided with the servo and a #0
Phillips screwdriver to secure the rudder servo in
the fuselage. Use care not to push too hard on the
mounting rails while tightening the screws.
 7. Repeat steps 3 through 6 to install the elevator
servo in the fuselage.
 8. Connect a 3-inch (76mm) servo extension to
each of the servo leads. Use a piece of dental floss
to secure the leads so they do not accidentally
disconnect inside the fuselage.
 9. Route the leads and extensions for the elevator
and rudder servos to the front of the fuselage,
exiting at the top hole in the motor box.