E-flite Cessna 150 Aerobat 250 ARF - Manual (Page 16)

16 E-flite Cessna 150 Aerobat 250 ARF Assembly Manual
 3. Use hook and loop tape to secure the receiver in
the fuselage. Pass the leads for the aileron servos
into the cabin area of the fuselage. Tuck the leads
from the speed control inside the opening with the
receiver.
 4. Route the aileron extension through the large
opening in the fuselage as shown. Roughly 3/8-inch
(10mm) will stick out from the side of the fuselage.
 5. Use medium CA to glue the aileron extension to
the fuselage along the former.
 6. Repeat steps 4 and 5 to route the remaining
aileron servo extension.
horizontal Stabilizer Installation
Required parts
Fuselage assembly Wing panel (right and left)
Carbon wing tube Stabilizer with elevator
Required Tools and Adhesives
Felt-tipped pen Hobby knife with #11 blade
Thin CA Ruler
Paper towels Rubbing alcohol
 1. Slide the carbon fiber wing tube into the socket
in the wing panel. The tube socket has a cap on it,
so do not force the tube in any farther than it will
easily slide.
 2. Slide the carbon fiber wing tube into the
fuselage. Connect the aileron extension to the
extension in the fuselage. Guide the aileron
extension into the wing.