E-flite Cessna 150 Aerobat 250 ARF - Manual (Page 25)

25 E-flite Cessna 150 Aerobat 250 ARF Assembly Manual
Motor Battery, Cowl, propeller and
Spinner Installation
Required parts
Assembled airframe Battery hatch cover
Hook and loop tape Cowling
Propeller
Spinner assembly (optional, not included)
Required parts (park 250)
Motor battery, 430mAh 2S 7.4V
Required parts (park 280)
Motor battery, 450mAh 3S 11.1V
Required Tools and Adhesives
Scissors Razor saw
Thin CA Phillips screwdriver: #1
Open-end wrench: 6mm
 1. Use scissors to cut a piece of the softer hook and
loop tape the length of your battery. Place the tape
on the battery as shown.
 2. Cut a piece of the stiff hook and loop tape
using scissors. It should be long enough to fit from
close to the front of the battery tray to the rear
holes as shown. Apply the tape in position. Wick
thin CA around the edges of the tape to secure it
to the plywood.
 3. Place the battery in the fuselage. Its final position
will be determined when setting the CG.
 4. Use a razor saw to remove the spreader bar
from the cowling. Use care not to break the former
out of the cowling while sawing.
 5. Slide the cowling on the fuselage. The pins in the
cowling will position the cowl and the magnets will
hold the cowl to the fuselage.