E-flite Cessna 150 Aerobat 250 ARF - Manual (Page 15)

15 E-flite Cessna 150 Aerobat 250 ARF Assembly Manual
 4a. (Park 250) Attach the motor to the firewall
using the plywood spacer and two 2mm x 10mm
self-tapping screws. Use a #1 Phillips screwdriver to
tighten the screws, securing the motor to the firewall.
Do not over tighten the screws or you could strip out
the holes.
 4b. (Park 280) Attach the motor to the firewall using
two 2mm x 6mm self-tapping screws. Use a #1
Phillips screwdriver to tighten the screws, securing
the motor to the firewall. Do not over tighten the
screws or you could strip out the holes.
If using all E-flite components, match all the
corresponding wire colors between the ESC and motor.
 5. Connect the leads from the motor to the speed
control.
 6. Secure the speed control to the fuselage using
hook and loop tape and a tie-wrap (not included).
Make sure the wiring is neatly tucked away so it
will not interfere with the operation of the motor or
installation of the cowling.
Receiver Installation
Required parts
Fuselage assembly Receiver
Y-harness Hook and loop tape
6-inch (152mm) servo extension (2)
Required Tools and Adhesives
Scissors Dental floss
Medium CA
 1. Plug the Y-harness into the aileron port of the
receiver, and the adapter into the throttle port. Use
dental floss to secure a 6-inch (152mm) extension to
the leads of the Y-harness as shown.
 2. Plug the rudder and elevator servos into the
correct ports of the receiver. Plug the speed control
into the adapter that is plugged into the throttle port.