E-flite 4-Site F3P 250 ARF - Manual (Page 6)

6 E-flite 4-Site Assembly Manual
 7. Locate the horizontal stabilizer. Note the coloring
scheme on the top of the stabilizer. Carefully fold
the elevator on the stabilizer as shown so it can be
installed into the fuselage.
 8. Slide the folded horizontal stabilizer into
the fuselage. Unfold the elevator and position
the stabilizer, but do not apply any glue to the
stabilizer at this time.
 9. Repeat Steps 1 though 5 to install the right
upper diagonal fuselage brace with foam-safe CA.
Again, make sure to work slowly and use a square
to keep the alignment of your fuselage in check.
You will not glue the lower right diagonal brace
until later in the build.
 10. Locate the Depron firewall. Note the alignment
points on the firewall and how they relate to
fuselage. The alignment points are located on
the top and left (as viewed from the front of the
fuselage) as up and right thrust are built into your
model. Use foam-safe CA to install the Depron
firewall in the fuselage.