E-flite 4-Site F3P 250 ARF User Manual
Page 17
17
E-flite 4-Site Assembly Manual
6. Test fit the aileron servo in the hole in the bottom
of the bottom wing. The output of the servo will
face the tail of the aircraft. Once fit, use a low-
temperature glue gun or foam-safe CA to adhere
the servo to the wing.
7. Plug the servos into the receiver at this time.
You may need to plug an adapter in the receiver
to connect the lead from the speed control as well.
Use hook and loop tape to secure the receiver to
the fuselage.
Use clear tape to neatly organize the servo leads.
It is possible for the ends of the pushrods to
come loose in packaging and shipping. It is a
good practice to check these ends. If they are
loose, reglue the ends by placing a drop of
foam-safe CA at each end of the heat shrink.
8. Insert the bend of the 23
5
/
8
-inch (600mm)
rudder pushrod into the servo arm. Use the third
hole in from the end of the servo arm as shown.
Not to scale
9/16-inch
(14mm)
It might be easier to insert the pushrod if you remove
the horn from the servo. If this is done, just make sure
that you center it when placing it back on the servo.