E-flite 4-Site F3P 250 ARF - Manual (Page 4)

4 E-flite 4-Site Assembly Manual
Fuselage Construction
Required Parts
Main fuselage Stabilizer
Depron firewall Left horizontal fuselage
Right horizontal fuselage
Left upper diagonal brace
Right upper diagonal brace
Left lower diagonal brace
Required Tools and Adhesives
Square Foam-safe CA
If you lay the fuselage on the edge of a flat surface
so that the landing gear doubler is hanging
off of the edge and just the top half above that
is on the table it will allow you to keep the
fuselage very straight during the first steps.
Landing gear doubler
Work surface
 1. Locate the left horizontal fuselage and main
fuselage. The left horizontal fuselage will be
printed on top and white on the bottom. Test fit the
horizontal fuselage to the main fuselage. Check
that the horizontal fuselage lines up at the front
with the main fuselage.
 2. When gluing the horizontal fuselage to the main
fuselage, do not apply glue toward the tail after
the last tab. This is necessary to properly install the
horizontal stabilizer.
 3. Remove the horizontal fuselage from the main
fuselage. Apply a bead of foam-safe CA to the
left horizontal fuselage where it contact the main
fuselage. Do not apply CA to the rear section of the
horizontal fuselage as noted in the previous step.