E-flite 4-Site F3P 250 ARF - Manual (Page 11)

11 E-flite 4-Site Assembly Manual
 8. While keeping the stabilizer in alignment,
apply foam-safe CA to the left and right horizontal
fuselage as well as the left and right diagonal
braces to secure them to the fuselage and stabilizer.
 9. Use a T-pin to poke a hole through the hinge
tape at the hole where the carbon bracing for the
stabilizer will go through.
 10. Use foam-safe CA to install the two 5
3
/
4
x
1/32-inch (145mm x 1mm) carbon rods that
brace the stabilizer. Use the drawing from Step 8
as a guide for positioning the stabilizer. It must be
parallel to the top and bottom wings, as well as
straight across and flat as shown. You can also use
a square to help with this alignment.
Landing Gear Installation
Required Parts
Assembled airframe
6
7
/
8
x 3/32-inch (175mm x 2.5mm) carbon rod,
Main landing gear (2)
Landing gear support
Wheel skid (2)
Required Tools and Adhesives
Sandpaper Foam-safe CA
Thin CA
 1. Use foam-safe CA to glue the landing gear
support to the bottom of the bottom wing. Make
sure the support is aligned with the leading edge of
the wing and the center points are aligned.