E-flite 4-Site F3P 250 ARF - Manual (Page 20)

20 E-flite 4-Site Assembly Manual
 21. Once the pushrods are connected to the control
horns, apply a drop of foam-safe CA to the heat
shrink tubing. Apply CA to both the pushrod and
control horn side to secure the tubing to each.
 22. Use foam-safe CA to glue the two 1 x 3/32-
inch (2 x 25mm) carbon rods in the slots in the
top and bottom ailerons. Make sure the rods
are parallel and centered with the ailerons when
installed.
 23. Connect the 6
7
/
8
-inch (175mm) carbon rod to
the control horn of the upper aileron using a piece
of heat shrink and a soldering iron.
 24. Use side cutters to trim the carbon rod to the
proper length. Use a piece of heat shrink and a
soldering iron to make the connection between the
top and bottom ailerons.
 25. Apply a drop of foam-safe A to the heat shrink
at both the top and bottom ailerons. Make sure to
apply CA to both the pushrod and control horn.
 26. Repeat Steps 22 through 25 to connect the
remaining top and bottom aileron.
 27. Remove the tape used to keep the control
surfaces centered at this time.