E-flite 4-Site F3P 250 ARF - Manual (Page 21)

21 E-flite 4-Site Assembly Manual
Final Assembly
Required Parts
Assembled airframe Propeller
Propeller adapter
Wheel pant (2)
Motor battery Hook and loop tape
Required Tools and Adhesives
Foam-safe CA
Important Information About Your Propeller
It is very important to check to be sure the
propeller is balanced before installing onto the
shaft. An unbalanced propeller may strip the
gears or cause poor flight characteristics.
If it is necessary to enlarge the hole in
the propeller or the spinner, make sure to
check the balance of each afterwards.
 1. Locate the propeller adapter (included with
motor) that fits your particular model. Insert the
adapter in the propeller, making sure it is installed
in the backside of the propeller.
 2. Mount the propeller following the instructions
provided with your motor.
 3. Foam-safe CA is used to glue the wheel pants
to the wheel skids. A small notch in the wheel pant
will align with the center ridge on the wheel skid.
Make sure there is clearance between your work
surface and the wheel pants so they do not rub
during take-off or landing.
 4. Use scissors to cut a 25mm piece of hook and
loop tape. Peel the backing from the softer side and
attach it to the battery.
 5. The battery attaches roughly 25mm in front
of the elevator servo. The exact position can be
adjusted to correct the Center of Gravity if it is not
correct according to this manual.