E-flite 4-Site F3P 250 ARF - Manual (Page 10)

10 E-flite 4-Site Assembly Manual
 4. Using a square, install the 4
1
/
8
x 1/32-inch
(105mm x 1mm) carbon rods between the left and
right outer struts and bottom wing as shown. Make
sure to keep the bottom wing flat on your work
surface and not to deflect the outer struts between
the top and bottom wings when installing the
carbon rods.
 5. Install the remaining 4
1
/
8
x 1/32-inch (105mm
x 1mm) carbon rods between the left and right
outer struts and top wing as shown. Make sure to
keep the top wing flat and not to deflect the outer
struts between the top and bottom wings when
installing the carbon rods.
 6. Use foam-safe CA to install the two 5
5
/
16
x
1/32-inch (135mm x 1mm) carbon rods between
the top wing and fuselage as shown. Use care not
to induce any warps in the top wing while installing
the braces.
These two (2) rods affect the wing in many different
ways. Use caution to make sure that the wing stays
flat and is also still perpendicular to the fuselage.
 7. Check the alignment between the wings and
stabilizer. Position the stabilizer so it is parallel to
both the top and bottom wings as shown. It should
also be square to the fuselage. Check to make sure
that the wing and stabilizer are also perpendicular
to the fuselage.
Adjust stabilizer parallel to wings
Adjust perpendicular
to fuselage