E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 27)

27 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 17. From the fuselage, run the rigging up to the upper
front hole in the outer strut.
 18. Apply light tension on all the rigging at this time. Use
foam-safe CA to glue the end of the rigging in position
once the rigging has been tensioned. Once again take
a look and ensure there are no warps in the two wings.
Using a hobby knife, trim off the remaining thread once
the CA has cured.
 19. To complete the rigging of your model, go back and
apply a drop of foam-safe CA to each position where the
rigging passes through a strut and through the fuselage.