E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 22)

22 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 4. Carefully press the gear into the slots at the front and
rear into the fuselage.
Note: You may put a drop of foam-safe CA at each
corner of the fuselage where the landing gear exits to
help secure it to the airframe.
Wing Rigging Installation
Required Parts
• Airframe • Rigging thread
Required Tools and Adhesives
• Foam-safe CA • Thin CA
• Needle • Hobby knife
Note: Installing the rigging will add to the appearance
and strength of your airplane, but you will not be able to
remove the wings without cutting the rigging. The rigging
is required on your S.E.5a. DO NOT fly your model
before installing the rigging.
Hint A: You may want to thread the rigging through a
needle to make it easier to pass the rigging through
the holes, especially the tubes in the fuselage near the
bottom wing.
Hint B: Another option is to soak the last 2 inches
(50mm) of the rigging line with thin CA to stiffen it up so
you can pass it through all the holes.