E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 11)

11 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 11. Turn on your radio system and select a new model if
using a computer radio. Make sure all the sub trims have
been set to 0 and no mixing functions are turned on.
Center the trim levers and stick at this time as well. Plug
the servos into the radio system and make sure all servos
operate and are centered as well.
 12. Install the servo arms on the rudder and elevator
servos prior to installation. The servos will have the arms
installed as shown in the photo.
 13. Using a pin drill with a 1/16" drill bit, mount the
elevator and rudder servo in the fuselage using the
screws provided with the servo.
Note: Another option would be to glue the servos in with
a drop of foam safe CA over the screw lugs.