E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 18)

18 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 5. Position the tail onto the fuselage and check that they
rest parallel to the top and bottom wings. If not, lightly
sand the fuselage where the tail rests to correct any
alignment problems. Use foam-safe CA to glue the tail to
the fuselage once the tail is aligned to the wings.
Radio Installation
Required Parts
• Assembled fuselage • 2mm x 4mm machine screw (2)
Required Tools and Adhesives
• Phillips screwdriver: #0
• Pliers • Side cutters
 1. Make a 90-degree bend 1/2-inch (13mm) from the
end of the wire pushrod as shown.