E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 10)

10 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 7. Position the motor so is does not rub against the cowl.
Apply a few drops of foam-safe CA to the intersection of
the motor box and motor tube. Apply CA to the tube at
both the front and rear of the motor box.
  8. Use a pin drill and 1/16-inch (1.5mm) drill bit to
enlarge the outer hole in the servo arm. Slide the micro
pushrod connector into the hole.
  9. Secure the micro pushrod connector using a micro
pushrod connector backplate.
 10. Repeat Steps 8 and 9 to prepare a second
servo arm.