E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 25)

25 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 9. Apply light tension on all the rigging at this time. Use
foam-safe CA to glue the end of the rigging in position
once the rigging has been tensioned. Ensure you have
not built a warp into the wings during this process. A
quick sight from the front will verify there are not warps.
 10. Using a hobby knife trim, off the remaining thread
once the CA has fully cured.
 11. To complete the rigging, follow basically the same
routing, only in reverse. Start by securing the rigging to
the rear lower hole as shown with foam-safe CA.
 12. Route the rigging up to the rear of the cabane strut.