E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 24)

24 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 5. The rigging then will go from the front lower hole to
the upper rear hole, crossing the outer strut.
 6. Route the rigging from the outer strut to the rear
hole in the fuselage. This is where having a needle or
hardening the rigging will come in quite handy.
 7. The rigging then goes from the fuselage to the upper
rear hole in the outer strut.
 8. Cross the rigging from the rear upper hole back
down the front lower hole where this section of rigging
was started.