E-flite S.E.5a Slow Flyer 250 ARF - Manual (Page 15)

15 E-flite S.E.5a Slow Flyer ARF Assembly Manual
 5. Using a ruler, check the alignment of the bottom wing
to the fuselage. The distance from each wing tip to the
end of the fuselage will be equal when the wing is in
alignment. Move the wing as necessary to adjust the
alignment until both measurements are equal.
 6. Using a #1 Phillips screwdriver, repeat Steps 2 through
4 to install the remaining three #2 x 5/8-inch sheet metal
screws that hold the bottom wing to the fuselage.
 7. The installation of the top wing is identical to that of
the bottom wing. Follow Steps 2 through 6 to attach the
top wing to the cabane struts.
 8. Locate the two outer struts. Use medium sandpaper to
remove the clear coat from the top and bottom of the strut
where it contacts the top and bottom wings. Use a pin
drill and 1/16-inch drill bit to open the holes if they have
been sealed by the clear coat as well.