E-flite Hawker Sea Fury 480 ARF - Manual (Page 11)

11 E-flite Hawker Sea Fury 480 ARF Assembly Manual
 3. Lift the hatch from the fuselage as shown.
 4. Remove the battery stop from the inside of
the fuselage by sliding it rearward and out of
the fuselage.
Important Information About your Brushless ESC
Make sure your ESC brake is programmed
to Off. Also, be sure to use an ESC with the
proper low-voltage cutoff and have it set
correctly for the batteries you are using.
Never check the motor rotation on the bench
with the propeller installed. The plane could
move and cause serious injury. Always check the
motor without the propeller to avoid injury.
 5. Connect the battery and servo lead extensions to
the speed control. Secure them using string to prevent
them from being unplugged inside the fuselage.
 6. Pass the battery and servo extensions into the
lower hole in the fuselage and into the main radio
compartment as shown below.
 7. Secure the speed control inside the motor
compartment using double-sided tape.