DJI Ronin - Manual (Page 30)

30 © 2014 DJI. All Rights Reserved.
Ronin User Manual
Connecting the Remote Control to Ronin
1. Turn on the Ronin.
2. Slide the power switch to the right to power on the remote control. If the power LED indicator is
solid, the remote control is functioning normally. To the right, the battery level indicators display the
current battery status. The LED indicator on the Ronin gimbal will blink red at this time.
3. Press and hold the Bind Button (shown below) for a few seconds until the LED blinks green
three times. If the LED changes to a solid, red light, the remote control and the Ronin have been
successfully bound. The binding process only needs to be done once unless the bind button is
pressed or if the Ronin needs to be bound to another remote control.
Bind Button
Please make sure the battery level of remote control is enough before use. If the low voltage
warning alert sounds (refer to ), please
recharge the battery as soon as possible.
Charge the remote control battery by using the included micro-USB cable. Using the
incorrect type of charging cable may cause damage.
Turn off the remote control before charging. The power LED indicator will display solid
green when the battery is fully charged.
Remote Control
Remote Control Power LED Indicator Status
Power LED Indicator Sound Remote Control Status
— Solid Green None Functioning normally.
— Solid Red None Charging( remote control is powered off)
— Solid Yellow None
Remote control joysticks calibration error. Needs to be
re-calibrated.
— Solid Red BB---BB---BB Low voltage (from 3.5V-3.53V). Recharge the remote control.
Quick Red flashing B-B-B......
Critical low voltage (from 3.45V-3.5V). Recharge the
remote control immediately.
Slow Green flashing B--B--B......
Alert will sound after 15 minutes of inactivity. It will stop
once you start using the remote control.
The remote control will power off automatically when battery voltage drops below 3.45V.
Charge the battery as soon as possible when the low voltage alert occurs.