DJI Ronin User Manual

Page 26

Ronin

User Manual

The onboard controller and the remote operator control sticks have a Deadband, Maximum Speed, and

Smoothing, all of which can be set independently.

Endpoint: Pan Axis endpoints can be adjusted independently for left and right movement when used with a

remote control or the onboard controller. Tilt Axis endpoints can be adjusted independently for up and down

movement when used with a remote control or the onboard controller.

If the requirement to rotate 360 degrees on the Pan axis is needed, simply adjust the endpoints for pan to 0. If

endpoints are set to 0 for 360 degree Pan ability, then "Test Pan Endpoint" will not move the pan axis.

The Pan and Tilt endpoints can be tested. Ensure the camera is unobstructed when clicking the Test buttons.

Controller Priority: If both input devices send control signals to the gimbal, the selected controller priority will be

the only device to send a signal at that given time.

Pan/Tilt Remote Speed Adjustment: Click to choose combined or independent settings.

Speed Toggle Presets: These presets will allow you to change the SmoothTrack speed remotely. If the remote

control is turned on, the Speed Toggle Presets for SmoothTrack will take precedence over the Assistant

settings. Once the remote control is turned off, the SmoothTrack settings in the Assistant will take over.

Auto Tune Stability: The Auto Tune Stability button allows for automatic adjustment of each motor’s

stiffness settings (as relayed from the sensors and how the Ronin sees each axis’s interaction) to

accomplish an optimized setting.

Default: Click here to restore all of the factory settings.

2. Control

DJI PC / MAC Assistant Tuning