DJI Z15-GH3 - Manual (Page 25)

©2013 DJI Innovations. All Rights Reserved.
25
Trouble Shooting
NO. What Why How to
1
The gimbal keeps drifting
after initialization
(1) The TX trims are too much (1) Adjust the TX trims
(2) The GCU and autopilot
system is disconnected
(3) The Z15 mounting direction
is disaccording to aircraft nose
(2)Connect the GCU and flight
control system
(3)Ensure the Z15 mounting direction
is the same with aircraft nose
2
The gimbal is abnormal
after initializing
Abnormal calibration after
manufacture
Please contact the local dealer or
DJI Innovations customer service
3
Cannot distinguish the
gimbal pointing when
using
BVR flight
Switch to the FPV Mode first, then to
another Working Mode needed
4
The gimbal LED flashing
red
(1) The gimbal and camera
disconnected
(2)Camera is off
(3) Camera setup failure
(1)Make sure the cable connected
(2)Please power on the camera
(3)Set the HDMI resolution as 1080i
5
The gimbal green LED is
on but without video
display
(1) The wireless video
transmission unit disconnected
(2)Wrong power supply for
wireless video transmission unit
(1) Check the wireless video
transmission unit connection
(2) Ensure the power supply for
wireless video transmission unit is
12V
Specifications
General
Built-In Functions  Three Working Modes
 Orientation-locked control
 Non orientation-locked control
 FPV mode (Reset)
 Built-in independent IMU module
 DJI gimbal special servos drive module
 HDMI- AV module