DJI Z15-GH3 - Manual (Page 22)

©2013 DJI Innovations. All Rights Reserved.
22
1-Pilot Solution
RC Receiver
(Futaba)
3-Position Switch
3-Position Switch
3-Position Switch
3-Position Switch
2-Position Switch
2-Position Switch
Gimbal Control
Aircraft Control
Tx
14-Channel
7
1
2
4
3
5
6
( AILE )
( ELEV )
(THRO)
( RUDD )
( GEAR )
(Collective Pitch)
(Control Mode Switch)
2-Position Switch
or

This is the example connection. Prepare one 14-channel TX/RC receiver for aircraft and gimbal control.

Setup the Aileron, Elevator, Throttle ，Rudder channels on TX for aircraft roll, elevator, throttle, rudder control,
and TX AUX2 for aircraft control modes(Please refer to the Flight Control System User Manual ).

Choose three 3-position switches for ROLL, TILT, and PAN rotation control. Switch center position is 0
velocity and end positions are maximum velocity.

Choose one 3-position switch/channel as Z15 Working Modes switch (MODE).

Choose one 2-position switch/channel as camera shutter control switch (SHUT), and one as HDMI switch
(AUX1).

Connect the receiver to GCU and Flight control System MC correctly.