Gcu wiring, Battery, 4s~12s) – DJI Z15-GH3 User Manual

Page 15: Wkm/ ace one/ ace waypoint

GCU Wiring

GCU Wiring

Gimbal Controller (GCU)

RC Receiver



These are example connections. Prepare 2 TXs, one is for gimbal control, the other one for aircraft control, refer to

2-Pilots

Solution

for more detail in

Appendix.



If one receiver is used for aircraft and gimbal control at the same time, refer to

1-Pilot Solution

for detail in

Appendix



Setup Aileron, Elevator, Rudder channels on gimbal control TX. Command stick stands for gimbal rotation velocity，center
position is for 0，endpoint for maximum velocity(both clockwise and counter clockwise directions). (End Point is 100%)



Choose one 3-position switch/channel as Z15 working modes switch.(MODE)



Choose one 2- position switch/channel As camera shutter control switch(SHUT), one for HDMI switch(AUX1), one for
camera lens orientation switch in Reset Mode (AUX2).



Please refer to WKM/ACE ONE/ACE Waypoint User Manual for aircraft control setting.



Connect the receiver to GCU correctly.

Battery



Connect the XT60 to the GIMBAL on center frame if S800 EVO used.



Attention that S800 EVO power supply voltage should be within the
defined limits (6S), when using one battery for both S800 EVO and
Gimbal power supply.



Please refer to

S800

EVO

User Manual

for details.

Battery

(4S~12S)



Make sure the ports are accessible when installing the MC so as to facilitate
wiring and software configuration.



In 3-pin ports, pins near the nicks are signal pins.



6-pin cable for G6, 8-pin cable for G8.



DO NOT cover the heat sinks, keep them unobstructed.



The IMU module is NOT water-proof or oil-proof.

Wireless Video
Transition Module

Air End

WKM/ACE ONE/ACE Waypoint

Please refer to WKM/ACE ONE/
ACE Waypoint User Manual for all
connection and configuration details.

WKM/

ACE ONE/

ACE Waypoint

Any spare CAN port on DJI

autopilot system

RC Receiver

(Aircraft control)

RC Receiver

(Futaba
/ Hitec)

2
4

RC Receiver

(JR)

AUX2

RUDD

ELEV

AILE

2-Position Switch

8-Channel

USB Port

PC connection for configuration and
firmware upgrades with an USB cable.

Heat

Sinks

Ensure the side with copper contacts is facing
upward towards the heat sinks.

2-Position Switch

S-Bus Receiver

(Futaba)

S-Bus

PPM Receiver

PPM

Turn to next page to obtain the
correspondence between t h e
GCU channels and S-Bus/PPM
channels.