DJI Z15-GH3 - Manual (Page 10)

©2013 DJI Innovations. All Rights Reserved.
10
Mount Gimbal to Landing Gear
Following diagram shows mounting gimbal to DJI Innovations S800 EVO. You may mount the gimbal to a landing
gear prepared by yourself referring to the following diagram.
step4: Install the gimbal to a landing gear with mounting bracket; tighten up the screws (2.5*8 Head-cup
screw×8) with appropriate screw glue.
Notes:
 Ensure to mount the side of servo driver module1 without ports to the aircraft nose direction.
 Make sure the top and bottom plates of damping unit stay parallel when mounting, preventing the
damping units from stretched and distorted.
 Keep overall balance when mounting, in order to make the center of gravity on the Z axis line.
 The gimbal center of gravity has been set, whose position directly determine the gimbal performance.
Please do not adjust the gimbal center of gravity by yourself.
 The gimbal is high-precision controlled. Do not remove any other screws in the gimbal, which may result
in bad performance or even damage.