DJI Z15-GH3 - Manual (Page 18)

©2013 DJI Innovations. All Rights Reserved.
18
AUX2 Switch Set
The Z15 supports to control the camera lens down or forward in Reset Mode. Please wire the right channel of
receiver to AUX2 port. You may assign: Position-1 to DOWN; Position-2 to FORWARD; or reverse the assignment.
Notes:
 This function can only work in FPV Mode (Reset).
 When this function is on, if the working mode switch from other modes to FPV Mode (Reset), the gimbal
will force the camera lens to face forward or down depending on AUX2 Switch.
 The camera orientation is forward while non-connection or disconnection.
Tips:
When the AUX2 is connected to Futaba S-Bus channel it is used as the S-Bus channel input.
Tx
1
2-position
switch
2