DJI Z15-GH3 - Manual (Page 14)

©2013 DJI Innovations. All Rights Reserved.
14
Video Signal Transmission
A wireless video transmission module is required for the video signal accessing remotely.
Wireless Video
Transmission Module
Air End
Disconnected
Video Signal(Yellow:AV)
GND(Black: )
Power
Video Signal
GND
Gimbal Video Power Cable
Video Signal Port
Connect to the power
source according to the
module
’s voltage and
current requirements.
step1: Carefully solder the corresponding Video Signal/GND cables to a wireless video transmission module
(Air End).
step2: Plug the gimbal video power cable lead into the GCU Video Signal Port.
Notes:
 Make sure to connect the wireless video transmission module to the GCU prior to powering on.
 The standard gimbal video power cable is recommended.
 Make sure you solder the gimbal video power cable to the wireless video transmission module correctly.
As the cable carries power, ensure the cables are insulated or wrapped to prevent any type of
short circuit.
Disconnected
Video Signal Cable(AV)
GND Cable
Connect the wireless video transmission module to a power source as the GCU cannot supply power. Make sure
the power is a safe voltage for you own devices according to the wireless video transmission module’s
requirement.
Tips:
 The following diagram shows how video signal transit when gimbal working.
 If the video signal access fails, please check each step.
Camera
HDMI
Gimbal
HDMI-AV module
HDMI signal
GCU
G8
AV signal
Wireless video
transmission
module
Air end
HDMI-AV cable 8-Pins cable
Gimbal Video
Power Cable
Wireless video
transmission
module
Ground end
Wireless signal
Monitor
AV input
5.8G/2.4G/1.2G
Self-prepared by user
AV signal
AV signal