Brandmotion 9002-7601-V2 - Manual (Page 3)

Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Installation Instructions (Kit # 9002-7601)
7601 Instructions 9-18-12.doc Page 3 of 3
Step 9: Secure Camera Harness to existing vehicle
wiring. This will minimize the chance of binding or
otherwise damaging the harness (Recommended: Wire
Ties or Electrical Tape.)
Step 10: Connect Chassis Harness to supplied
Power Harness.
Step 11: Install aftermarket display/ Navigation
display as per instructions (if required).
Step 12: Connect the male RCA from the Power
Harness to the “Camera IN” on the aftermarket
display/ Navigation display.
Note: Connection to female RCA connector shown.
Step 13: Test the system. Inspect that all connections
are proper and secure. Clear all loose items removed from
the area around the vehicle and turn ignition key ON to
test system.
Step 14: Adjust Camera angle (if necessary). Loosen
camera screw using supplied Allen wrench to aim the
camera. Tighten screw at desired adjustment.
Step 15: Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the harness
wiring when reinstalling.
NOTE: This camera has grid lines or non grid lines
and mirror image or non mirror image options.
Grid line options: Default setting is to display grid
lines. To remove the grid line display, connect the two
green wires near the end of the camera harness.
Display options: Default setting is mirror image
display for rearward facing camera (rear view)
installation. To change to non mirror image for
forward facing camera (front view) connect the two
white wires near the end of the camera harness.
Green and white wires on the camera harness.