Brandmotion 9002-7608 - Manual (Page 2)

INSTALLATION
INSTRUCTIONS
7608 Nissan NV Instructions 4-1-13.doc Page 2 of 2
Step 8: Route Chassis Harness forward along the
driver’s side of the vehicle.
Step 9: Connect Chassis Harness to supplied Video
Harness and route towards driver’s side kick panel.
(Note: connection is same as shown in Step 8.)
Step 10: (If necessary) Connect supplied Female to Male
RCA Adaptor to yellow RCA Video Harness plug.
Step 11: Install video monitor / Navigation display per
manufacturer’s instructions. See Chart A below for Reverse
signal location.
Step 12: Connect yellow RCA plug of Video Harness to
“Camera IN” on the video / Navigation display. (NOTE:
The white RCA plug is not used in this application.)
Step 13: Connect Camera Harness power connector to
the supplied Power Harness.
Step 14: Remove the driver’s side kick panel using a
plastic trim removal tool.
Step 15: Splice the red wire from the Power Harness to
blue 12v+ Ignition power wire (Recommended: T-taps or
Solder.)
Step 16: Add a Ground Eyelet (recommended) to the
black wire from the Power Harness and use a screw or
nut to attach it to Chassis Ground.
Chart A
Wire Color Polarity Function Description
Vehicle
Location
Red
Kit Power
Harness
12v +
Camera
power
Displays 12
volts + with
Ignition ON
Driver side
kick panel –
Blue wire
(located in
cavity 1 of
white 6-pin
plug)
Black
Kit Power
Harness
(–) Ground Ground Chassis
n/a
Varies—
refer to
mirror/
display
instructions
12v +
Back up
Lamps
(Reverse
signal)
Displays 12
volts + with
shifter in
Reverse
Driver side
kick panel –
Orange wire
(located in
cavity 4 of
white 4-pin
plug)
Step 17: Test the system. Inspect that all connections are
proper and secure. Clear all loose items removed from area
around the vehicle. Turn ignition key ON and shift into Reverse
to test system. The video image from the Camera should
appear in your display / Navigation display.
Step 18: Secure Chassis, Video, and Power Harnesses
to existing vehicle wiring and reassemble vehicle by
following your disassembly steps in reverse order. Avoid
binding or otherwise damaging the harnesses.
(Recommended: Wire Ties or Electrical Tape.