Brandmotion 1110-2518 - Manual (Page 2)

2518 Instructions 12-5-13.doc Page 2 of 2
Compass Calibration
Your Brandmotion mirror displays the current heading of your vehicle. Once the mirror is installed it is necessary to
calibrate and test the function of the compass.
1. To activate/deactivate the compass display, press and release the On button on the front of the mirror.
2. Set the Appropriate ZONE from the chart below. Press the N button on the mirror for 3 seconds until a number
appears on the display. Press and release the button to toggle through the available zones until the appropriate
zone is displayed. Wait 4 seconds and the zone will be stored in the mirror.
3. For the best calibration, switch off electrical equipment (climate control, wipers, etc.) and close all doors. Locate
an open level area free of steel structures and high voltage power lines where the car can be driven in circles at
5 MPH or less. If “C” is not displayed, press and hold the button for 6 seconds until “C” is displayed. Drive in
circles 2 -3 times until a direction is displayed.