Rockwell Automation 9220-TG QUICK START CONTROLNET MESSAGE User Manual

Page 20

ControlNet Message/Traffic Generator Tool

Publication 9220-10.1 — July 1996

The following table lists the parameters specified in CNXOR.CFG.

ControlNet Setup Parameters

This resource

Description

CN.name:

Provides a list of ControlNet setup names to be included in
the SETUP>CN PARAMETERS cascading menu.
These names are shown in the menu unless a CN.___.title
resource is provided for each name. The default parameters,
if present, will be loaded automatically upon startup of
the program.
CN.name: default setup2ms setup5ms

CN.___.title:

Provides a title to be displayed in the
SETUP>CN PARAMETERS cascading menu. If it is not
provided, the name will be displayed.
CN.default.title:

Default

CN.setup2ms.title: Worst Case PIT
CN.setup5ms.title: Normal PIT

CN.___.originatorPortNum:

Specifies the 9220-KTCT card to use for the setup.
Valid port numbers: 0–3.
CN.setup2ms.originatorPortNum: 0

CN.___.originatorMacId:

CN.___.targetMacId:

Specifies the network addresses (MAC IDs) of the originator
(9220-KTCT) and target devices. Valid address: 0– 99.
CN.default.originatorMacId: 1
CN.default.targetMacId: 2

CN.___.pit_time:

CN.___.smax:

CN.___.umax:

CN.___.slot_time:

CN.___.blank_time:

CN.___.gb_start:

CN.___.gb_center:

CN.___.redundancy:

CN.___.sched_max_frame:

CN.___.int_cnt_mod:

CN.___.gb_prestart:

CN.___.mcycle_start:

CN.___.mcycle_length:

CN.___.mcycle_count:

CN.___.mcycle_multiplier:

These parameters make up the ControlNet Object Attribute
to send to the 9220-KTCT’s ControlNet Object.
For definitions and information on range of values, see the
ControlNet Network Product Developer’s Guide,
PN 955121-04.
CN.default.pit_time: 200
CN.default.smax: 5
CN.default.umax: 6
CN.default.slot_time: 21
CN.default.blank_time: 6
CN.default.gb_start: 12
CN.default.gb_center: 9
CN.default.redundancy: 3
CN.default.sched_max_frame: 255
CN.default.int_cnt_mod: 255
CN.default.gb_prestart: 15
CN.default.mcycle_start: 0
CN.default.mcycle_length: 0
CN.default.mcycle_count: 1
CN.default.mcycle_multiplier: 8