Rockwell Automation 6181F_P Series E Integrated Display Computers User Manual - Manual (Page 62)

62 Rockwell Automation Publication 6181P-UM002D-EN-P - February 2014
Chapter 6 Maintenance
Clean the Heat Sink and Vent Holes
Perform the following steps to clean the chassis.
1. Disconnect power from the computer at the power source.
2. Disconnect all peripheral devices from the computer.
3. Vacuum dust and debris from the heat sink and vent holes.
Remove Paint and Grease from Bezel
Perform the following steps to remove paint and grease from the bezel of
computers properly mounted in NEMA Type 4/4X or IEC IP66 enclosures.
1. Close and lock the access cover on the front bezel.
2. Remove paint splashes and grease by rubbing lightly with isopropyl alcohol.
3. Use a mild soap or detergent solution to remove residue.
4. Rinse with clean water.
Backlight Assembly Disposal
ATTENTION: Step 1 does not apply to computers with a stainless steel
bezel.
ATTENTION: Make sure the isopropyl alcohol does not come in contact
with the equipment labels. Alcohol can cause the label printing to smear.
ATTENTION: The backlight assembly in this computer can contain mercury. At
the end of its life, this equipment should be collected separately from any
unsorted municipal waste.