Rockwell Automation 2100-ENET CENTERLINE 2100 Motor Control Centers EtherNet/IP Network Adapter - Manual (Page 38)

38 Rockwell Automation Publication 2100-UM006A-EN-P - July 2013
Chapter 4 Configure the I/O
10. Click Finish to add the E3 Plus EtherNet/IP network adapter to the I/O
Configuration in RSLogix 5000 software.
Save the I/O Configuration to the Controller
After adding the bridge and the end device to the I/O configuration, you must
download the configuration to the controller. Also save the configuration to a file
on your computer.
1. In the RSLogix 5000 window, from the Communications menu, choose
Download.
The Download dialog box appears.
TIP When using RSLogix 5000 software, version 16 or later, you can add the I/O
configuration of a Generic Profile while the controller is online and in the Run mode.
TIP If a message box reports that RSLogix 5000 software is unable to go online, from the
Communications menu, choose Who Active to find your controller in the Who Active
dialog box. After finding and selecting the controller, click Set Project Path to establish
the path. If your controller does not appear, you need to add or configure the EtherNet/
IP network driver in RSLinx software. See
Use RSLinx Classic Software on page 25 for
details.