Rockwell Automation 61C544A RTD Module - Manual (Page 13)

3Ć1
3.0 INSTALLATION
This section describes how to install and remove the module and its
cable assemblies.
DANGER
THIS UNIT AND ITS ASSOCIATED EQUIPMENT MUST BE INSTALLED,
ADJUSTED, AND MAINTAINED BY QUALIFIED PERSONNEL WHO ARE FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF ALL EQUIPMENT IN THE
SYSTEM AND THE POTENTIAL HAZARDS INVOLVED. READ AND UNDERSTAND
THIS MANUAL AND OTHER MANUALS APPLICABLE TO THE EQUIPMENT IN
YOUR INSTALLATION. FAILURE TO OBSERVE THESE PRECAUTIONS COULD
RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
DANGER
THE USER IS RESPONSIBLE FOR CONFORMING WITH ALL APPLICABLE
LOCAL, NATIONAL, AND INTERNATIONAL CODES. WIRING PRACTICES,
GROUNDING, DISCONNECTS, AND OVERCURRENT PROTECTION ARE OF
PARTICULAR IMPORTANCE. FAILURE TO OBSERVE THIS PRECAUTION COULD
RESULT IN SEVERE BODILY INJURY OR LOSS OF LIFE.
3.1 Wiring
To reduce the possibility of electrical noise interfering with the proper
operation of the control system, exercise care when installing the
wiring from the system to the external devices. For more detailed
recommendations, refer to IEEE 518.
3.2 Initial Installation
Usethefollowing procedureto install themodule:
Step 1.
Turn off power to the system. All power to the rack as well
as all power to thewiring leading to themoduleshould be
off.
DANGER
THIS EQUIPMENT IS AT LINE VOLTAGE WHEN AĆC POWER IS CONNECTED.
DISCONNECT AND LOCK OUT ALL UNGROUNDED CONDUCTORS OF THE AĆC
POWER LINE. FAILURE TO OBSERVE THESE PRECAUTIONS COULD RESULT IN
SEVERE BODILY INJURY OR LOSS OF LIFE.
Step 2. Mount the terminal board assemblies (M/N 61C545) on a
flat panel or a DIN rail (M/N 61C546).
The terminal boards should be mounted to allow easy
access to thescrew terminals. Besuretheterminal board
assemblies are close enough to the rack so that the cables
(M/N 61C545 or M/N 61C546) will reach between them
and theRTD modulein therack. Thecables arefivefeet
long. Seefigure3.1.