Rockwell Automation 61C613 16 Channel Analog Input Module - Manual (Page 47)

HĆ1
Appendix H
AutoMate Program Command
Register Table
REGISTER DATA ADDRESS COMMENTS
20,000 0049 M+ 0 RESET
20,001 0000 M+ 1 NOOP
20,002 0000 M+ 2 NOOP
20,003 0000 M+ 0 INTIALIZE SETUP
20,004 0000 M+ 1 SETUP
20,005 0000 M+ 2 SETUP
20,006 0020 M+ 0 WRITE CHANNEL REGISTER
20,007 WWWW M+ 1 CHANNEL NUMBER
20,010 0000 M+ 2 DISABLE AUTOĆINCREMENT ON
CHANNEL NUMBER
20,011 0010 M+ 0 CONFIGURE CHANNEL INPUT
20,012 XXXX M+ 1 TYPE OF ANALOG INPUT (SEE TABLE)
20,013 0000 M+ 2 NOOP
20,014 0016 M+ 0 CONFIGURE CHANNEL SLOPE
20,015 YYYY M+ 1 LOW ORDER BYTE
20,016 ZZZZ M+ 2 HIGH ORDER BYTE
20,017 0018 M+ 0 CONFIGURE CHANNEL OFFSET
20,020 YYYY M+ 1 LOW ORDER BYTE
20,021 ZZZZ M+ 2 HIGH ORDER BYTE
20,022 0004 M+ 0 CONFIGURE SCAN RANGE
20,023 0000 M+ 1 START AT CHANNEL 0
20,024 0015 M+ 2 STOP AT CHANNEL 15*
20,025 0000 M+ 0 INITIALIZE SCAN
20,026 0000 M+ 1 NOOP
20,027 0008** M+ 2 60 HZ,CENTIGRADE, 16 BIT MODE
CONTINUOUS SCAN
20,030 0024 M+ 0 READ ANALOG INPUT CHANNEL
20,031 0000 M+ 1 CHANNEL NUMBER POINTER
20,032 0000 M+ 2 NOOP
* USER MUST DEFINE THE LAST CHANNEL USED; DEFAULT IS 15 IN THIS
CASE.
** 0008 = 1 0 0 0
ąąąąPOWER LINE FREQUENCY; 0 Ć 60Hz, 1 Ć 50Hz
ąąąTEMPERATURE UNITS
0 = CENTIGRADE, 1 = FARENHEIT
Note: This is only used with the T/C kind codes.
ąąDATA ACQUISITION MODE
0 = ONĆCOMMAND, 1 = CONTINUOUS SCAN