Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 21)

8Ć1
8.0 INSTALLING THE
OPTIONAL SHAREDĆUSER
DPS SOFTWARE
This chapter describes how to install the sharedĆuser version of the
DPS software (M/N 57C650). The sharedĆuser DPS software allows
up to five users to simultaneously run the Executive software with
DPS software options. The software is installed on the network
server only.
Note that the individual DPS software options are not included in the
sharedĆuser DPS software. The options must be installed separately
after or before the sharedĆuser DPS software.
Prerequisites for Installation
1. You must install the sharedĆuser Executive software before
installing the sharedĆuser DPS software.
2. You must install the separatelyĆpurchased singleĆuser DPS
software option(s) required for your application. Any number or
combination of DPS software options is permitted.
3. IMPORTANT: The installation procedure for M/N 57C650 below
is used when you initially install the sharedĆuser DPS software. If
you have purchased M/N 57C650 for the purpose of adding
additional users to an existing sharedĆuser DPS installation, you
must use the procedure described in chapter 9.
During the installation procedure, the following subdirectories will be
created on the hard disk if they do not already exist:
:\RPE\
:\RPE\\TEMP
:\AMXWORK
Install the sharedĆuser DPS software on the network server following
the directions below. This procedure must be performed before
installing the sharedĆuser DPS software on each network node.
Step 1.
To begin installing the DPS software, insert the disk
labeled 1" in floppy drive A: or B:.
If you are installing from the Windows Program Manager application,
type the following after selecting Run from the Files menu:
:\INSTALL.EXE
where:
is the drive in which you have placed the disk.
If you are installing from Windows 95:
Click on Start and choose Run; type
:\INSTALL.EXE.
Where:
: is the disk drive in which you placed the disk.