0 - installing the shared-user executive, 0 installing the sharedćuser executive – Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install User Manual
Page 13
5Ć1
5.0 INSTALLING THE
SHAREDĆUSER EXECUTIVE
This chapter describes how to install the sharedĆuser version of the
Executive software, which allows up to five users to run the
Executive simultaneously (M/N 57C620, M/N 57C621). Installation of
the sharedĆuser Executive requires two separate procedures.
The first procedure, in section 5.1, describes how to install the
Executive on the network file server. This procedure must be done
first.
The second procedure, in section 5.2, describes how to install the
Executive on each network node that will use the Executive
software.
During the installation procedure, the following subdirectories will be
created on the network file server disk if they do not already exist:
For DPS Users:
If you install sharedĆuser Executive software and you want to install
any DPS software options, you must first install the sharedĆuser DPS
software. See chapter 8 for more information.
5.1
Installing the SharedĆUser Executive on a
Network Server
Install the sharedĆuser Executive on a network server following the
directions below. This procedure must be performed before
installing the sharedĆuser Executive on each network node.
Step 1.
To begin installing the Executive software, insert the disk
labeled 1" in floppy drive A: or B:.
If you are installing from the Windows Program Manager application,
type the following after selecting Run from the Files menu:
where:
If you are installing from Windows 95:
Click on Start and choose Run; type
Where:
Before installing any files, the install program will display two
messages. The first message describes the type of installation
(Shared 5 User or Shared 5 User Upgrade); the second lists the
number of disks required for the install procedure and the amount of
hard disk space required for the Executive software.