Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install User Manual
Page 17
6Ć1
6.0 INSTALLING ADDITIONAL
5ĆUSER LICENSES FOR
SHAREDĆUSER EXECUTIVE
SOFTWARE APPLICATIONS
The number of users having access to the sharedĆuser Executive
software on a network can be increased by using the additional 5Ć
user license (M/N 57C622). The sharedĆuser Executive software
must already exist on the network.
Use the following procedure to add five users to the sharedĆuser
Executive. Note that the installation procedure is divided into two
parts. The remainder of this chapter describes the first part,
installing the additional 5ĆUser license on the network server. The
second part, installing the software on each individual new node, is
the same as that used for installing the base 5ĆUser license
Executive, which is described in section 5.2. Be sure to follow the
procedure in this order: steps in chapter 6.0, then steps in section
5.2.
Step 1.
Insert the Executive software disk labeled Add Users" in
floppy drive A: or B:.
Type A:\ADDUSER
You will be prompted for the network server directory where the
Executive software is located.
Step 2.
Press ENTER to accept the default, or enter the directory
path.
The current number of users will be displayed, and you will be
prompted for the new user limit.
Step 3.
Enter the old number of users plus 5. (five maximum with
each license).
The new total number of users will be displayed.
Step 4.
Run the network node install procedure (see section 5.2)
on each of the new nodes.
Step 5.
If you have DPS software options installed, you must
install another copy of the sharedĆuser DPS software in
order to be able to access DPS features on the five new
network nodes.