Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install User Manual
Page 12
4Ć2
The install procedure will install new AutoMax task skeleton files
(SKELETON.*). After the install procedure is completed, you must
update the new skeleton files with any custom information from your
old skeleton files (USKELTON.*), and then delete the old skeleton
files.
Step 4.
The install procedure will begin writing files to your hard
drive. After disk 1 is installed, you will be prompted to
replace disk 1 with the floppy disk labeled 2", and so
forth for the remaining disks. Be sure to respond
appropriately each time to the OK" prompt to continue
the installation. The Executive software will occupy
approximately 7 megabytes of memory on the hard disk
when installed.
The installation routine:
D copies files
D creates icons
D places files in the Windows directory
D installs ASD.
You can abort the installation procedure at any point by selecting
Exit. If you abort the installation procedure, you will be given the
option to delete all of the files in the
subdirectories.
Step 5.
A text file, README.AMX, contains information on the
enhancements made for AutoMax V3.x. You will be
prompted for whether you want to read the file or not. If
you select Yes", the file will be displayed. If you select
No", you can read or print out the file later by selecting
the Read Me" icon from the AutoMax Executive group.
Step 6.
The following line will be added to the AUTOMAX.INI file
by the install procedure:
EXEC_DRIVE=
where
subdirectory where the Executive software was installed.
Step 7.
When the installation has been completed, a message
will be displayed.
Step 8.
Install any DPS software options required for your
application. See chapters 4, 5, and 6 for more
information.