Rockwell Automation 2755 Hand-Held Cordless Bar Code Scanners - Manual (Page 150)

Application Examples A–33
Publication 2755-6.6
AdaptaScan Bar Code Readers Setup
You may need to configure the AdaptaScan RS-232 port to accept
the scanner data. Verify that the AdaptaScan serial port is configured
as shown below. All settings use the default values except for the
Enable Pass-Through to DeviceNet check box. Refer to the
AdaptaScan Software User Manual (Publication No. 2755-838) for
additional information.
1. Default is Terminal.
2. Default is
9600 Baud.
4. Defaults are:
No Parity,
8 Data and
1 Stop Bit.
3. Default message
length is 0 (sends all
data regardless of
length).
5. Default is
RS-232 Connection.
6. Enable
Pass-Through.